Skip to product information
1 of 1

Evans Cooling Products

Evans Cooling System Flush

Regular price $28.95 USD
Regular price Sale price $28.95 USD
Sale Sold out

COOLING SYSTEM FLUSH

Complete cleaner for high mileage or older cooling systems
**1 bottle cleans a 4 gallon system- follow mixing instructions**


Removes rust and scale from high mileage or older cooling systems in preparation for the installation of Evans Waterless Coolant.

INSTRUCTIONS:
1. Determine cooling system capacity (refer to owner's manual).
2. * When engine is cool, remove cap, open draincock and drain cooling system (remove block drains if applicable). Collect used antifreeze for disposal. When disposing used antifreeze/flush, please follow local laws and regulations.
3. Flush with water until water runs clear.
4. Close all drains.
5. Install flush (refer to chart).
6. Once the appropriate amount of flush is installed into the radiator, fill system with water.
7. Place heater on highest setting.
8. Drive vehicle for 2 hours at normal temperature. DO NOT let sit idling, MUST drive!
9. Allow engine to cool to room temperature. NEVER WORK on a HOT system!
10. Drain system. * * Remove block drains if applicable, drain radiator and heater core.
11. Flush with water until it runs clear. This will neutralize the flush.
12. Start the installation process to convert to Evans Waterless Coolant by following the standard Evans installations.

Note* It is essential that you adhere to the dosage recommendation chart as overdosing of the flush is not recommend and could cause harm to your cooling system.

WARNING: Reproductive Harm - www.P65Warnings.ca.gov

System Capacity(gallons)

Evans Flush(ounces)

1

16oz.

2

32oz.

3

48oz.

4

64oz.

5

80oz.

6

96oz.

7

112oz.

8

128oz.

9

144oz.

10

160oz.



Other Evans Cooling Products available for any chassis/engine - if you don't see what you’re looking for please message us directly.
We shop our competition - if you find a lower comparable price we will match or beat it - message for details!
PROPOSITION 65 WARNING: These products may contain chemicals known to the State of California to cause birth defects or other reproductive harm. For more information visit www.P65Warning.ca.gov

About

Water-based antifreezes have been used in car engines for about a century, but water can cause major problems inside engines, including corrosion, boil-over, and engine breakdowns. Waterless coolants can prevent engine overheating and reduce cooling system maintenance, and can last much longer than a water-based coolant.

Most engine coolants/antifreezes are a 50/50 mix of ethylene glycol and water. Waterless coolant is a glycol-based fluid that is ready to use, no water required.
Water has superior heat transfer capabilities but water’s low boiling point is close to the operating temperature of an engine, and water can cause corrosion.
Waterless coolants provide sufficient heat transfer, boil at a higher temperature, and are non-corrosive.
Evans is the only manufacturer of waterless antifreeze.
Installing Evans waterless coolant eliminates many problems associated with water in conventional water-based cooling systems, while increasing reliability and engine life.